HYDRO. DRIVE AND BRAKE SYSTEM
53
11. Disconnect the drive control rod from the trun-
nion arm of the hydro. See Figure 5.76.
12. Disconnect the spring at the end of the transmis-
sion release rod from the by-pass arm on the
transaxle. See Figure 5.77.
NOTE: The closed end of the spring hooks
downward into the rod.
13. Support the transaxle so that it can be lowered
out of the tractor in a controlled fashion.
Figure 5.76
Drive control rod Trunnion arm
Spring
Cotter
pin
Figure 5.77
release rod
Transmission
Spring
By-pass arm
14. Remove the torque bracket bolts using a 1/2”
wrench. See Figure 5.78.
15. Take the nuts off of the T-bolts that hold the tran-
saxle to the frame using a 1/2” wrench.
See Figure 5.79.
NOTE: At this point, the brake actuator spring is
still attached to the brake rod from the pedal
shaft, and the brake arm on the transaxle.
Figure 5.78
Torque bracket
Bolts
Figure 5.79
To Next Page
Loading...
