Cupra ATECA - Page 124

Operation
Adjusting the headrests
Fig. 98
Front seat: headrest adjustment.
Fig. 99
Rear headrest: headrest adjustment.
Adjusting the height of the headrests
●
Grab the sides of the headrests with both
hands and push up
w
ards to the desired posi-
tion. To lower it, repeat the same action,
pressing the
1
›
›
›
Fig. 98
›››
Fig. 99 button
on the side.
●
The headrest must lock correctly in one
position.
Removing and fitting the headrests
Fig. 100
Rear headrest: removal.
Removing and fitting the front headrests
●
Move the headrest upwards until it arrives
t
o the t
op.
●
Press the side button
›››
Fig. 98
1
and re-
mo
v
e the headrest.
●
To refit, insert the headrest into the holes
in the backrest, pushing it down until it en-
gages.
Removing the rear headrests
To remove the headrest, the corresponding
backrest must be partially folded forward.
●
Unlock the backrest
›››
page 123.
●
Move the headrest upwards until it arrives
to the top.
●
Press button
›››
Fig. 100
1
, while simulta-
neously pr
essing on the securit
y hole
2
with
a flat scr
e
wdriver a maximum of 5 mm wide,
and remove the headrest.
●
Move the backrest until it engages properly
›››
in Folding down and raising the rear
se
at backr
est on page 123.
Fitting the rear headrests
To mount the external headrests, the corre-
sponding backrest must be partially folded
forward.
●
Unlock the backrest
›››
page 123.
●
Insert the headrest bars into the guides
until they perceptibly engage. It should not
be possible to remove the headrest from the
backrest.
●
Move the backrest until it engages properly
›››
in Folding down and raising the rear
se
at backr
est on page 123.
WARNING
Remove the rear headrests only when it is
necessary to fit a child seat. After removing
a child seat, refit the headrest immediately.
122