Cupra ATECA - Page 255

Driver assistance systems
●
The Front Assist does not r
eact to pedes-
trians walking head-on in the same lane.
●
The driver must always be ready to take
over the control of the vehicle.
Note
●
When Front Assist is connected, the indi-
cations of other functions on the screen
may be hidden.
●
When the Front Assist causes a braking,
the brake pedal is “harder”.
●
Automatic interventions by the Front As-
sist on the brakes may be interrupted by
pressing the clutch, accelerator or moving
the wheel.
●
The Front Assist may brake the vehicle
until it stops completely. However, the
brake system does not halt the vehicle per-
manently. Use the foot brake!
●
If the Front Assist does not work as de-
scribed in this chapter (e.g. in intervenes
several times unnecessarily), switch it off.
Radar sensors
Fig. 211
On the front bumper: radar sensors.
A radar sensor is installed on the front bump-
er t
o det
ermine the traffic situation
›››
Fig. 211
1
.
The r
adar sensor's visibilit
y may be impaired
by dirt, or by environmental influences such
as rain or mist. In this case, the Front Assist
does not work. The instrument panel dis-
plays the following message: Front Assist:
No sensor vision! Clean the radar sensor
›››
.
When the r
adar sensor be
gins to operate
properly again, the Front Assist will be availa-
ble again. The message will disappear from
the screen.
Front Assist operation may be affected by a
strong radar reverse reflection. This may oc-
cur, for example, in a closed car park or due
to the presence of metallic objects (e.g.
guard rails or sheets used in road works).
The area in front of and around the radar
sensor should not be covered with adhe-
sives, additional or similar headlights, as this
may negatively affect Front Assist operation.
If the front of the vehicle is not properly re-
paired or structural modifications are made
to it, Front Assist operation may be affected.
This is why CUPRA recommends visiting a
specialised CUPRA dealer or any SEAT deal-
ership.
CAUTION
If you have the feeling that the radar sensor
is damaged or has lost its settings, discon-
nect the Front Assist. This will avoid possi-
ble dangerous situations caused by the in-
adequate operation of the system. If this
occurs have it adjusted.
●
The sensor may not be adjusted correctly
if it receives an impact. This may compro-
mise the system's efficacy or disconnect it.
●
Repairs to the radar sensor require spe-
cialist knowledge and special tools. This is
why CUPRA recommends visiting a special-
ised CUPRA dealer or any SEAT dealership.
●
A registration plate or plate holder on the
front that is larger than the space for the
registration plate, or a registration plate
that is curved or warped can cause the ra-
dar to malfunction.
»
253