EasyManua.ls Logo

Cupra ATECA - Page 266

Cupra ATECA
380 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving
Control lamp
It lights up yellow
Lane Assist system active but not available.
The system cannot accurately recognize the lane.
See page 265, lane assist system not available (the
control lamp is lit up in yellow)
It lights up green
Lane Assist system active and available.
It lights up yellow
Error in the lane departure warning system. Take the
vehicle to a specialised workshop to repair the fault.
Some control and warning lamps will light up
briefly when the ignition is s
wit
ched on to
check certain functions. They will switch off
after a few seconds.
WARNING
Observe the safety warnings
in Con-
trol and w
arning lamps on page 79.
Indications on the instrument panel
display
Fig. 223 On the instrument panel display: Indica-
tion on the Lane Assist system display (example 1).
Fig. 224
On the instrument panel display: Indica-
tion on the Lane Assist system display (example 2).
Status display
Fig. 223 : The s
y
stem is active, but not
available, either because the minimum
speed has not been reached or because
the lane lines are not recognised.
Fig. 223 : The system is active and
available, both lane lines are recog-
nised. The steering angle is not being
corrected at this moment.
264

Table of Contents

Related product manuals