Curtiss-Wright DTS1 - Page 2

Curtiss-Wright DTS1

140 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

This Page Intentionally Left Blank

Table of Contents

Front Matter3
Safety4
Style and Conventions5
Table of Contents6
List of Figures11
Table of Contents11
List of Tables12
Introduction13
Quality13
Ordering Process14
Technical Support14
Overview15
Description15
Chassis15
- Figure 2.2 DTS1 Chassis / Components16
- DTS1 Rear Panel / Battery Access Cover and Rear Connectors17
- DTS1 with RMC Module17
- RMC Module17
- Account Creation18
- Csfc Encryption18
- Hardware Encryption Layer18
- Protocols18
- Account Login19
- Hardware Encryption Layer Account Creation19
- Features20
- Software Encryption Layer20
- Zeroize20
Figure 4.1 DTS1 Chassis Anti-Tamper Label Locations26
DTS1 Chassis Mounting27
- Figure 4.2 RMC Module Anti-Tamper Label Location27
  - Figure 6.1 Initialization Quick Start Process Flow48
  - Login49
  - Login Quick Start Process Flow50
  - Operation51
- Cables28
- DTS1 Rear Panel Connectors28
- DTS1 Required Door Clearance28
- Power Cable28
- Ethernet Cable29
- Utility Cable29
- Utility Lab Cable29
- DTS1 Ground Connection30
- Ground Cable30
- Encryption31
- Hardware Layer Passwords31
- Passwords / Passphrases31
- Software Layer Passwords / Passphrases31
- Check Hardware Layer Status32
- Hardware Layer Definitions32
- Hardware Layer Encryption33
- Hardware Encryption Key Storage35
- Autoload Key37
- Load / Unload Stored Hardware Encryption Key to RMC Module37
- Software Layer Encryption38
- Unpartitioned Disk38
- Close SWE Container (Unpartitioned Disk)39
- Format / Mount SWE Container (Unpartitioned Disk)39
- Open SWE Container (Unpartitioned Disk)39
- Delete SWE Container (Unpartitioned Disk)40
- Partitions40
- Initialize SWE Encryption (Partitions - same Passphrase)42
- Zeroize HWE Key / Delete SWE Container / RMC Purge45
- Connections / Preparation47
- Initialization47
- Quick Start47
  - Figure 2.1 DTS151
  - Figure 7.1 DTS1 Test Setup51
  - Figure 7.3 Putty Terminal Emulator (SSH)53
  - Account Management54
  - IP Address54
  - Passwords54
  - Time / Date55
  - Storage Media56
  - Partition Disk57
  - Assign Services58
  - Services58
  - Boot Services59
  - Restart Services59
  - Assign Mount Point Names60
  - Format / Mount61
  - Format Only61
  - Example of RMC Module Status62
  - Pcap65
  - Health66
  - Sens66
  - Built in Test67
  - IBIT (Initiated BIT)67
  - MBIT (Maintenance BIT)67
  - Update Software / Firmware68
  - Access from Windows as NAS Device69
  - DTS1 Update Utility69
  - Access from Linux as NAS Device70
  - Crypto Module71
  - Dts171
  - Key Commands71
  - System Configuration71
  - RMCCTL Definitions72
  - Chassis LED Fault Indicators74
  - Troubleshooting74
  - Encryptor Error Codes75
  - Simple Network Management Protocol77
  - Snmp Mib77
- Basic Operation52
- Communications52
- Putty Terminal Emulator (Serial Data)52
- Terminal Emulation52
- Ethernet53
- Figure 11.1 RMC Module Install / Remove80
- Figure 11.2 RMC Module Controls, Indicators, and Handle81
- Figure 11.3 Battery Assembly Replacement82
- Figure 11.4 Battery Access Panel Screws Tightening Sequence82
- Command Line Interface83
- Cmkey87
- Cmlogin90
- Fwall96
- Help98
- Example: IBIT Execution99
- Ibit99
- Info100
- Ipconfig102
- Istarget104
- Ledctrl106
- Log107
- Ntpdate110
- Reboot114
- Rmcctl115
- Rmcfree118
- Rmcinfo119
- Rmcpurge121
- Rtp122
- Envelope / Mounting Dimensions129
- Specifications129
- Panel Mount130
- DZUS Fastener Mount131
Table A.1 DTS1 / RMC Calculated Mean Time between Failures132
- RMC Module Specifications132
- DTS1 Specifications132
- DTS1 / RMC Calculated Mean Time between Failures133
- Connectors / Cables135
- Power Connector J1 / Power Lab Cable135
- Power Lab Cable (VS-DTS1PWRCAB-0)135
Table B.1 Power Connector J1 Signals135
Utility Connector J2 / Utility Lab Cable136
Table B.3 Utility Connector J2 Signals136
- Ethernet Connector J3 / Ethernet Lab Cable137
- Utility Lab Cable (VS-DTS1ETHCAB-J2)137
Figure B.3 Utility Connector J2137
Figure B.4 Utility Lab Cable Diagram137
Table B.5 Ethernet Connector J3 Signals138
Table B.6 Ethernet Lab Cable (VS-DTS1ETHCAB-J3138
- Ground Lug139
- Ordering Information140
Table C.1 DTS1 Csfc Chassis140
Table C.2 RMC Module140
Table C.3 DTS1 Lab Cables140
Table C.4 DTS1 Battery140
Figure A.1 RMC Module140

Related product manuals

Curtiss-Wright VS-DTS1SL-F