Curtiss-Wright DTS1 User Manual

User Guide DDOC0099-000-AH
DTS1 CSfC 7 - 10 Operation
© 2020 Curtiss-Wright Defense Solutions Revision 4.0
Example of RMC Module Status
Transfer boot-up configuration to live configuration.
Command:
serv -a 2
Example of RMC Module Status
7.5.4 Assign Mount Point Names
NOTE
The RMC module must be partitioned to assign mount point names. Each mount point name must
be unique. Mount point names must be between 1 and 32 characters, some names might be
truncated depending on CLI.
Add a mount point name to a 100GB RMC module with 1 partition.
Command:
rmcctl --mntpoint [name]
Example of RMC Module Status (Where [name]=alpha)
Change the mount point name of a 100GB RMC module with one partition.
Command:
rmcctl --mntpoint [name]
Example of RMC Module Status (Where [name]=aaa)
Add a mount point name to partitions 1 and 2 of a100 GB RMC module with two partitions.
NOTE
Must be done as two separate commands.
Command:
rmcctl -p 1--mntpoint [name 1]
rmcctl -p 2--mntpoint [name 2]
cw_dts> rmcctl
[serv]
BOOTCFG cifs=1 nfs=1 ftp=1 http=1 dhcp=0 tftp=0 tel=0 snmp=0 status=ok
LIVECGFG
cifs=1 nfs=1 ftp=1 http=1 dhcp=1 tftp=1 tel=1 snmp=1 status=ok
[!rmcctl] OK
cw_dts> rmcctl
[serv]
BOOTCFG cifs=1 nfs=1 ftp=1 http=1 dhcp=0 tftp=0 tel=0 snmp=0 status=ok
LIVECGFG
cifs=1 nfs=1 ftp=1 http=1 dhcp=0 tftp=0 tel=0 snmp=0 status=ok
[!rmcctl] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 100GB NAS 0 na 0 na 0
alpha
[!rmcctl] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 100GB NAS 0 na 0 na 0
aaa
[!rmcctl] OK

Curtiss-Wright DTS1 Specifications

General

Brand	Curtiss-Wright
Model	DTS1
Category	Storage
Language	English