Curtiss-Wright DTS1 - Figure 7.3 Putty Terminal Emulator (SSH); Ethernet

User Guide DDOC0099-000-AH
DTS1 CSfC 7 - 3 Operation
© 2020 Curtiss-Wright Defense Solutions Revision 4.0
3. Configure PuTTY as follows:
• Connection type: Serial
• Serial line: COM1 (example - any computer serial port can be utilized)
• Speed: 9600
4. Click Open button.
 A terminal screen should activate.
5. Click Enter button.
 A login prompt should activate.
6. Log into CLI as follows:
a. At the login prompt type admin.
b. At the password prompt type istrator.
7.2.1.2 Ethernet
This section explains setting up communications using secure shell (SSH) and a PuTTY terminal
emulator.
1. If not previously accomplished, download a copy of PuTTY terminal emulator and install on
computer.
2. Open PuTTY terminal emulator (Figure 7.3).
Figure 7.3 PuTTY Terminal Emulator (SSH)
3. Configure PuTTY as follows:
• Connection Type: SSH
• Port: 22
• Host Name (or IP Address): see Table 7.1
4. Click Open button.
 A terminal screen should activate.
5. Click Enter button.
 A login prompt should activate.
DDOC0099-0033