User Guide DDOC0099-000-AH
DTS1 CSfC 4 - 1 Installation
© 2020 Curtiss-Wright Defense Solutions Revision 2.0
Installation
4.1 Package
NOTE
Either L-brackets or a Dzus mount is included depending on the ordered configuration.
The DTS1 package contents are listed below:
• DTS1 Chassis
• L-Brackets*
• Dzus Mount*
• Product Documentation CD
Optional Items (Refer to Ordering Information section for part numbers).
• RMC Module(s)
• Power Lab Cable
• Utility Lab Cable
• Ethernet Lab Cable
4.2 Inspection
The DTS1 is a two-part data storage system that consists of a DTS1 chassis and a RMC module.
Additional accessories may be included (if ordered). All received items should be inspected for
damage. Inspect all units as follows:
• All screws should be tight.
• The door gasket should be free from any cuts, crushing, or flattening damage
• All anti-tamper labels (Figure 4.1 and Figure 4.2) should be unbroken.
• All components should be free from any dents, cracks, or damage.
• All connectors pins should be present, straight, and undamaged.
If the DTS1 chassis or any accessories were damaged in shipping or the enclosure was breached,
immediately notify Curtiss-Wright Defense Solutions or your supplier.
Figure 4.1 DTS1 Chassis Anti-Tamper Label Locations
Anti-Tamper Label Locations
DDOC0099-0013
To Next Page
Loading...
Need help?
General
