User Guide DDOC0099-000-AH
DTS1 CSfC 7 - 5 Operation
© 2020 Curtiss-Wright Defense Solutions Revision 4.0
• Password: istrator
NOTE
The user can access the drives configured as network storage. The user cannot access the CLI.
User
• Username: user
• Password: password
NOTE
The admin account has configuration privileges while the user account has access to only network
storage functionality.
To change admin account password, type password -u admin -p [desired password]
and press ENTER key.
Example
To change user account password, type password -u user -p [desired password] and
press E
NTER key.
Example
The DTS1 software will prompt for the new password when -p command is used.
7.2.5 Time / Date
The time and date appear in some status displays and messages.
To display the current date and time, type sysdate and press ENTER key.
Example
NOTE
The date must be entered as yyyy/mm/dd. The time must be entered as hh:mm:ss
To change the current date, type sysdate -d yyyy/mm/dd and press E
NTER key.
Example
To change the current time, type sysdate -t hh:mm:ss and press E
NTER key.
Example
To change the current date and time, type sysdate -d yyyy/mm/dd -t hh:mm:ss and
press E
NTER key.
Example
7.3 Login
Logging into the DTS1 is a three-part process. Before the RMC module can be accessed or
configured, the user must (in the following order):
1. Log into DTS1.
2. Initialize HWE layer.
3. Log into HWE layer.
cw_dts>
password -u admin -p [desired password]
cw_dts>
password -u user -p [desired password]
cw_dts>
sysdate
cw_dts>
sysdate -d yyyy/mm/dd
cw_dts>
sysdate -t hh:mm:ss
cw_dts>
sysdate -d yyyy/mm/dd -t hh:mm:ss
To Next Page
Loading...
Need help?
General
