User Guide DDOC0099-000-AH
DTS1 CSfC 7 - 1 Operation
© 2020 Curtiss-Wright Defense Solutions Revision 4.0
Operation
CAUTION
CONFIGURATION ACCESS. Before attempting to setup or configure the DTS1, the Write-Enable
switch MUST be in the READ-WRITE position.
Before attempting to configure the DTS1, set the write-enable switch to the READ-WRITE
position. Refer to paragraph 3.2.2 Write-Enable Switch for detailed location information. After
configuring the unit, set the write-enable switch to the READ position.
NOTE
Throughout this section, yellow highlighted text is used to denote user-defined or software-gener-
ated inputs. Green highlighted text is used to show changes in values, settings, or responses due
to implementation of a software command.
7.1 Setup / Connections
NOTE
The DTS1 is powered by a user-supplied 28 VDC power supply and does not have a power switch
of its own. The DTS1 is powered up by turning on the 28 VDC supply.
1. If not previously accomplished, connect cables to DTS1 connectors (Figure 7.1).
2. If not previously accomplished, connect cables to terminal / PC connectors.
3. Turn on 28 VDC power supply.
Figure 7.1 DTS1 Test Setup
28 VDC
POWER
SUPPLY
GND
28 VDC RTN
28 VDC
DDOC0099-0016
4
3
2
1
4
3
2
1
J1
P4
P2
P3
J1
J2
6
5
4
3
2
1
12
11
10
9
8
7
13
19
18
17
16
15
14
6
5
4
3
2
1
12
11
10
9
8
7
13
19
18
17
16
15
14
J2
P2
P2
6
5
4
3
2
1
12
11
10
9
8
7
13
19
18
17
16
15
14
6
5
4
3
2
1
12
11
10
9
8
7
13
19
18
17
16
15
14
J3
C1
B1
A1
D1
ZEROIZE
POWER DISABLE
RESET
RS-232
ETHERNET
C2
B2
A2
D2
ETHERNET
NETWORK / TERMINAL / PC
SERIAL PORT
ETHERNET PORT
ETHERNET PORT
DTS1
P1
P1
P1
J1
To Next Page
Loading...
Need help?
General
