User Guide DDOC0099-000-AH
DTS1 CSfC 5 - 12 Encryption
© 2020 Curtiss-Wright Defense Solutions Revision 6.0
5.4.2.3 Initialize SWE Encryption (Partitions - Same Passphrase)
CAUTION
DATA LOSS. Initializing the software encryption layer will overwrite / destroy any existing data on
the partition. As a result, the --force option must be used.
Initialize the SWE containers on all partitions of a 100GB RMC module as follows:
1. Type rmcctl -p all --force -C and press E
NTER key.
2. Partition 1
a. After the above command has be issued, the user must acknowledge that all data on the
partitions will be overwritten
b. At the overwrite query prompt type YES and press E
NTER key.
NOTE
Refer to paragraph 5.1.2 Software Layer Passwords / Passphrases for requirements.
c. Enter a partition 1 password / passphrase that complies with the password / passphrase
requirements and press ENTER key.
d. Reenter the password / passphrase and press E
NTER key.
If the passphrase is entered correctly both times and meets the requirements the
following message will be displayed: RMC_C0; action=cryp status=OK.
3. Partition 2
a. At the overwrite query prompt type YES and press E
NTER key.
b. Enter the same password / passphrase for partition 2 and press ENTER key.
c. Reenter the password / passphrase and press E
NTER key.
If the passphrase is entered correctly both times and meets the requirements the
following message will be displayed: RMC_C0; action=cryp status=OK.
Example of RMC Module Status
5.4.2.4 Open SWE Container (Partition - Same Passphrase)
NOTE
The SWE containers must be opened before they can be used.
Open the SWE containers on all partitions of a 100GB RMC module as follows:
1. Type rmcctl -p all -E and press ENTER key.
2. Partition 1: Enter the password / passphrase and press E
NTER key.
3. Partition 2: Enter the password / passphrase and press E
NTER key.
If the passphrase is entered correctly the following message will be displayed:
RMC_C0; action=enter status=OK ‘Resetting attempts to 0”.
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 1 50 GB NAS
1 0 na na 0 rmc0p1
RMC_S0: 1 1 1 2 50 GB NAS 1 0 na na 0 rmc0p2
[!rmcctl] OK
To Next Page
Loading...
Need help?
General
