User Guide DDOC0099-000-AH
DTS1 CSfC 12 - 2 Command Line Interface
© 2020 Curtiss-Wright Defense Solutions Revision 5.0
12.3.1 amnt
NOTE
The DTS1 has only 1 RMC slot. As a result, the -s option is always -s 0.
Description
The amnt command is used to determine the configuration of the RMC auto mounter/starter
daemon. The conditions that allow auto-mounting of NAS RMCs, and the auto-starting of iSCSI
targets can be configured. When an action is not requested, the current state is reported. The
default operation for NAS RMCs / partitions to auto mount at POR or the first insertion. The default
operation for iSCSI RMCs to NOT auto-start the iSCSI targets. Configuring an RMC/partition to be
NAS or iSCSI is done with the --serv command.
Syntax
amnt [-h | --help | --version]
amnt [-s slotnum] [--off] [--on] [--key] [--nas] [--iscsi] [--por] [--fin] [--sin]
[--can] [--ro] [--restart]
Options
-h, --help............................Print help message.
--version............................Print program version.
-s, --slot <slotnum> ..........Slot number where the RMC is located(0,1,2,A). For all slots, use A
or all. Omission will select slot 0.
--off, off, 0 ..........................Disable an option, or the auto mounter/starter capability as a whole.
--on, on, 1.............................Enable an option, or the auto mounter/starter capability as a whole.
--key, key.............................Configure auto key loading of the crypto unit
--nas, nas.............................Configure the auto mounting of NAS file systems on the RMC
described by --slot.
--iscsi, iscsi .......................Configure the auto starting of iSCSI targets on the RMC described
by --slot.
--por, por .............................Configure the operation at POR of the RMC described by --slot.
--fin, fin...............................Configure the operation at the first insertion of the RMC described
by --slot.
--sin, sin..............................Configure the operation at subsequent insertions of the RMC
described by --slot.
--can, can.............................Configure the operation at canceled removals of the RMC described
by --slot.
--ro, ro .................................Make the RMC mount read only, or the iSCSI target start read only.
An RMC that is write-protected will automatically use this option.
--blk, blk <blk size>.............Configure the auto starting of iSCSI targets with this block size.
Valid sizes are 512, 1024, 2048, and 4096. The default block size
is 4096, the same as the istarget CLI command.
--restart, restart................Restart the auto mounter/starter daemon for the RMC described by
--slot.
Example: Status display
Line Identifier
AMT_S# .................................Current automounter status of RMC in slot "#"
Enumerated types
<summary> ............................Command status summary (OK, ERR)
Example: Control commands
Turn off auto-mounting on slot 0 completely
cw_dts> amnt
[amnt]
AMT_S#: AMNT KEY iPOR iFIN iSIN iCAN iRO iBLK nPOR nFIN nSIN nCAN nRO
************************************************************************
AMT_S0: 1 0 1 0 0 0 0 512 1 0 0 0 0
[!amnt] <summary>
amnt -s 0 --off
To Next Page
Loading...
Need help?
General
