User Guide DDOC0099-000-AH
DTS1 CSfC 12 - 15 Command Line Interface
© 2020 Curtiss-Wright Defense Solutions Revision 5.0
Line Identifier
FIREWALL .............................Current fireWall status
Enumerated types
<summary> ............................Command status summary (OK, ERR)
Example: Control commands
Display firewall status
Unmask firewall
Start firewall
Enable firewall at boot
Stop firewall
Disable firewall at boot
Mask firewall
Restart firewall
Reload firewall permanent rules
Add eth0 to firewall
Add ftp service to firewall
Remove ftp service from firewall
Add udp port 7777 to firewall permanently
Remove udp port 7777 from firewall permanently
Pass command to firewall-cmd
fwall --status
fwall --unmask
fwall --start
fwall --enable
fwall --stop
fwall --disable
fwall --mask
fwall --restart
fwall --reload
fwall --add --iface --eth0
fwall --add ftp
fwall --rem ftp
fwall --add --perm --port 7777 udp
fwall --rem --perm --port 7777 udp
fwall --cmd "--list-services"
To Next Page
Loading...
Need help?
General
