REPLACING AIR FILTER (H)
1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Stop the engine and raise the car-
go bed.
3. Open the cover of the air lter can-
ister to replace the lter.
4. Make sure to fit the filter to the
center of the canister.
5. Install the canister cover after
checking that the anti-dust valve is
facing downward without any gap.
(1) Filter (2) Cap
(3) Evacuator Valve
UUVo713A
If there is a tiny gap caused by a
loose connecting clamp on the air
hose, air without passing through the
air lter could enter the system for a
long period of time, resulting in short-
ening the service life of the engine.
Carry out the check according to the
service intervals in this manual as
follows.
CHECKING AIR HOSE AND CLAMP( I )
(1) Clamp 1 (2) Clamp 2
1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Stop the engine, remove the seat
cushion and raise the cargo bed.
(In case the hydraulic dumping kit
is installed, raise the car go bed
before stopping the engine.)
3. Check if the clamps (1 and 2) are
loose. If so, tighten them.
4. Check if there is tiny cracks or
aws on the rubber hose and re-
place it if necessary.
UUVo714A
To Next Page
Loading...
