Cushman 646442 - Checking And Changing Rear Axle Oil (U); Checking and Changing Rear Axle Oil (U)

7
-29
MAINTENANCE
7
1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Stop the engine and let the engine
cooled down sufciently.
CHECKING AND CHANGING REAR AXLE OIL (U)
3. Clean around filler plug, then re-
move the ller plug.
4. Check that the differential case
surface is not hot. Then, check the
oil level and condition with a nger
bent slightly. If you cannot reach
the oil, it means the oil level is low.
Add some oil.
5. If the color or viscosity of the oil is
not normal or it is at the oil change
interval, change the oil.
6. To change oil, place a container
with wide opening under the drain
plug. Then, remove the drain plug.
7. After draining all the oil, install the
drain plug rmly.
UUVo738A
UUVo739A
(1) Filler Plug
(1) Drain Plug
UUVo763A
(1) Funnel
8. W h e n a d d in g n ew o i l , a d d i t
through a long hose into the fill
plug location. Fill till oil starts to
spill out of ller plug hole.
9. Check the oil level by performing
the step 4 in the previous page. If
the oil level is normal, install the
ller plug.
Oil Capacity 0.21 U.S Gal. (0.8 L)
UTV-EZGO-Hauler 4X4 Diesel-07.in29 29 2015-05-26 오전 9:43:21