STOPPING THE ENGINE
Never touch the mufer or heat
shield until the engine is suf-
ciently cooled down.
Failure to do so could result in
serious injury on burns.
WARNING
Apply the parking brake and
remove the key from the key
switch before leaving your ve
-
hicle. An unauthorized person
or child can move or operate
the vehicle, resulting in an in-
jury or accident.
This vehicle is equipped with
a CVT (Continuous Variable
Transmission). Therefore, the
vehicle may roll down a slope
if the parking brake is not en
-
gaged even though the shift le-
ver is in the "H", "L" or "R" po-
sition.
CAUTION
1. Make sure to reduce the engine
rpm before stopping the engine.
2. Put the shift lever in the neutral
position.
3. Apply the parking brake.
4. Run the engine at idle speed for
approx. 2 to 3 minutes, and then
turn the key switch to the “OFF”
position to stop the engine.
5. Remove the ignition key.
If the vehicle is operated for an
extended period of time, idle
the engine at low speed for 2
to 3 minutes in order to cool
down the engine before shut-
down.
IMPORTANT
OPERATING PRINCIPLE OF
PREHEAT SYSTEM
1. When the key switch is turned to
the “ON” position, the glow plug
indicator comes on for 9 seconds
and then goes off . The engine
should be started within 3 seconds
after the glow plug indicator goes
off.
2. After the engine is started, post-
heat is performed without any indi-
cating lamp on. The post-heating
function keeps the glow plugs ac-
tivated for approx. 20 seconds af-
ter the engine is started in order to
enhance the engine combustion
performance and reduce harmful
emissions right after engine starts.
3. The preheat/post-heat function
and glow plug indicator do not op-
erate when the coolant temper-
ature is 30℃ (86
℉) or higher. In
this case, the engine can be start-
ed without the preheat operation.
4. In case extra preheating is needed,
hold the key in ( )position . Do not
preheat more than 30 seconds.
To Next Page
Loading...
