CHECKING SHIFT AND 4WD CABLES (AJ)
(1) Shift Cable (2) Nut 1
(3) 4WD Cable (4) Nut 2
1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Stop the engine, raise the cargo
bed and support it.
3. Unscrew nut 1 and adjust the
length of the shift cable.
4. Unscrew nut 3 and adjust the
4WD cable.
5. To check 4WD operation, lift the
front and rear axles completely off
the ground and support with jack
stands.
6. Start the engine and move the
2WD/4WD lever to "4WD" and
"2WD" positions to check rotation
of each wheel.
USING BIODIESEL (AK)
1. It is allowed to use 5% biodiesel
fuel. If biodiesel fuel of higher ratio
is used, the engine can be dam-
aged and this will not be covered
by warranty.
2. The biodiesel fuel should meet
A ST M D 6 7 5 1 , EN 1 4 2 1 4 a n d
equivalent standards.
3. For details about biodiesel use,
contact your Dealer.
Make sure that no one, espe-
cially children, near the vehi-
cle.
WARNING
You can get burnt by touching
hot parts, such as the mufer.
Make sure the vehicle is not
hot before starting servicing.
WARNING
UUVo760A
To Next Page
Loading...
