Cushman 646442 - Checking Differential Lock Cable (Ai)

7
-41
MAINTENANCE
7
CHECKING DIFFERENTIAL LOCK CABLE (AI)
(1) Differential Lock Cable
(2) Nut
1. Park the vehicle on level ground
and apply the parking brake rmly.
2. Stop the engine, raise the cargo
bed and support it with the support
rod. (In case the hydraulic dump-
ing kit is installed, raise the car go
bed before stopping the engine.)

Driving with loose wheel nuts
is very dangerous and can
lead to overturn and collision.
Make sure that they are rmly
tightened.
WARNING

The tire ination pressure and
wheel nut tightness should be
inspected daily.
IMPORTANT

You can get burnt by touching
hot parts, such as the mufer.
Make sure the vehicle is not
hot before starting servicing.
WARNING
3. Unscrew the nut and adjust the
cable length.
4. To check the differential lock oper-
ation, lift the rear axle with a jack
so that the rear wheels are off the
ground.
5. Set the differential lock lever to the
"Lock" position and rotate one of
the wheels manually. It is normal
that the other wheel rotates in the
same direction.
6. Set the differential lock lever to the
"Unlock" position and rotate one of
the wheels manually. It is normal
that the other wheel rotates in the
opposite direction.
UUVo759A
5. After reinstalling the wheel after
inspection, tighten the wheel nuts
rmly.
UTV-EZGO-Hauler 4X4 Diesel-07.in41 41 2015-05-26 오전 9:43:25