Custom Audio Electronics K3 - Windows Phone Bluetooth Pairing

Once pairing is completed, do not turn
off Bluetooth communication. Otherwise,
communication will be interrupted.
Setting Bluetooth
Bluetooth
MY DIVICE
<device_BT ADDRESS> connect
i
<Bluetooth device>
OTHER DIVICE
9
NOTE: To print with an iOS device you need to install
the application “Custom Print” available in the download
area of the site
www.custom.biz.
Windows Phone
Turn on the printer and print
a setup report (see paragraph 6.1).
Make sure that the “Wireless” parameter on the printer
is set to “Bluetooth” and that the “AutoReconnect”
parameter is set to “Disabled” (see paragraph 6.4).
Write down the 16-digit serial number indicated
on the label of the printer (see paragraph 3.3).
Security Type................................... : WPA2
Mac Address.................................... : 00-00-00-00-00-00
Wireless........................................... : Bluetooth
Printer ID ......................................... : 000000000000000
Paring PIN ....................................... : 1234
AutoReconnect................................ : Disabled
Pairing ............................................. : Enabled
Printer Emulation............................. : CUSTOM/POS
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Hardware
Busy Condition ................................ : RxFull
S/N: <serial number>
R<n>P/N: <product code>
<rating>
ON/OFF
FEED
1
2
3
Make sure that the “Wireless” parameter on the printer
is set to “Bluetooth” and that the “AutoReconnect”
parameter is set to “Disabled” (see
paragraph 6.6).
Turn on the printer and print
a setup report (see paragraph 6.1).
Write down the 16-digit serial number indicated
on the label of the printer (see paragraph 3.4).
50