Install front access cover
Do not over tighten screws.
1. Place front access cover in place.
Qty.DescriptionItem
4Screw1
1Front access cover2
2. Install screws using a Phillips screwdriver.
Complete Installation
Operate the unit at all levels to verify proper operation.
Control Board Assembly
Tools Required:
• Phillips screwdriver
Disconnect power source
Unplug the power cord from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Page 121 of 202
Cybex 772A, 772AT Arc Trainer Part Number