CYBEX Arc Trainer 772A User Manual

Remove controller cover and incline unit
1. Remove screw securing controller cover using a Phillips screwdriver.
Qty.DescriptionItem
1Cable tie1
1Incline motor cable2
1Controller cover3
1Control board4
1Screw5
2. Remove controller cover.
3. Plug power cord into power outlet.
4. Begin striding.
5. Press the Quick Start and stop striding.
6. Press the Incline + key to incline to level 20.
7. Unplug the incline motor cable from the control board.
8. Unplug power cord from power outlet.
Remove linkage rods
1. Remove socket head cap screw (SHCS), flat washer, cap and spacer securing linkage rod using a
3/16” Allen wrench.
Qty.DescriptionItem
1
Screw, SHCS .250-20 x
.75
1
1Flat washer2
1Cap3
1Spacer4
1Linkage rod5
2. Lay linkage rod down on frame. Place a clean cloth in between linkage rod and frame to prevent
scratches.
3. Repeat steps 1 and 2 for other linkage rod.
Page 128 of 202
Cybex 772A, 772AT Arc Trainer Part Number

CYBEX Arc Trainer 772A Specifications

General

Brand	CYBEX
Model	Arc Trainer 772A
Category	Fitness Equipment
Language	English