CYBEX Arc Trainer 772A - Page 141

Install controller cover
1. Plug incline motor cable into control board.
Qty.DescriptionItem
1Cable tie1
1Incline motor cable2
1Controller cover3
1Control board4
1Screw5
2. Place the controller cover into position.
3. Install screw securing the cover in place using a Phillips screwdriver.
Install front access cover
Do not over tighten screws.
1. Place front access cover in place.
Qty.DescriptionItem
4Screw1
1Front access cover2
2. Install screws using a Phillips screwdriver.
Complete Installation
Operate the unit at all levels to verify proper operation.
Incline Motor
Tools Required:
• Side cutter
• Phillips screwdriver
• Long Phillips screwdriver
Page 141 of 202
Cybex 772A, 772AT Arc Trainer Part Number