Install CardioTouch screen
1. Place the new CardioTouch screen in place in the bezel.
Qty.DescriptionItem
1Bezel1
1CardioTouch screen2
1Clip3
7Screw4
2. Install seven screws and clip, tighten by hand.
3. Tighten the seven screws in the order shown to 4 in-lbs (0.45 Nm) using a torque screwdriver.
4. Connect the ground cable connector to the tab on fan mounting plate or optional E3 View Monitor
if installed.
5. Screw the coax cable to the optional E3 View Monitor if installed.
Page 174 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
