CYBEX ATON Q User Manual

ADJUSTING THE SEAT
The Aton Perfect Positioner™ consists of a headrest, no
rethread harness and padded insert. The Perfect Positioner
may be adjusted up and down through eight positions to
perfectly t your baby.
The Aton Q is shipped in the lowest position with the Padded
Insert already folded.
1. Unbuckle the Harness and Chest Clip
2. Place the child in the Infant Carrier, making sure
the buttocks are sitting in the very bottom of the
seat, with their crotch at the crotch strap.
3. Adjust for your baby by pulling up on the gray plastic Positioner
Ring while sliding the Perfect Positioner up until the Harness
Slots are even with or slightly below your child's shoulders.
Periodically check for proper strap height as your child grows.
If your child's shoulders fall below the Harness Slots, even in the
lowest position, the lower portion of the Padded Insert should be
folded under at the seam in order to boost your child up for proper
Harness t.
Unfold the Insert when no longer needed to reach the Harness Slots.
If needed, fold the Padded Insert
under at the seam to boost your
child up for proper Harness t.
19
a
For proper use of the Infant Carrier, the Harness
shoulder straps MUST be AT or BELOW your child's
shoulders.
USING THE INFANT CARRIER

CYBEX ATON Q Specifications

General

Headrest	Yes
Washing type	Machine wash
Certification	ECE R44/04
Mounting type	Seat belt
Product color	Green
Car seat group	0+ (0 - 13 kg; 0 - 18 months)
Country of origin	Germany
Belt fastening type	3-point
Placement available	Rear-facing
Maximum weight capacity	13 kg
Maximum washing temperature	30 °C
Number of headrest positions	8
Quantity	1

Weight and Dimensions

Depth	650 mm
Width	440 mm
Weight	4600 g
Height (max)	560 mm
Height (min)	390 mm