CYBEX ATON Q - Cleaning Methods and Components

SPOT CLEANING
Spot clean Seat Covers, Shoulder Pads, Buckle Pad, and the
Infant Insert as needed with a clean cloth using mild detergent and
water.
WASHING INSTRUCTIONS
Seat Cover, Shoulder Pads, Buckle Pad, and the Infant Insert may
be washed as follows:
40C
Machine wash cold, gentle cycle, mild detergent
40C
Do not bleach
40C
Do not tumble dry
40C
Line dry
40C
Do not iron
HARNESS STRAPS
Sponge clean using warm water and mild soap. Air dry. Do not iron.
HARNESS BUCKLE
Sponge clean or thoroughly rinse Harness Buckle with warm water.
Test by fastening and unfastening until an audible CLICK is heard
after inserting each buckle Tongue into the Buckle. If CLICKS are
not heard, repeat the cleaning procedure.
LATCH CONNECTORS
Sponge clean or thoroughly rinse LATCH Connectors with
warm water. Allow to dry thoroughly. Test by connecting and
disconnecting until an audible CLICK is heard after connecting
each connector to a lower LATCH anchor. If clicks are not heard,
repeat the cleaning procedure.
PLASTIC PARTS
Wipe clean with mild detergent and warm water.
45
NEVER remove Harness or Harness components from
Infant Carrier.
NEVER use bleach, household cleaners or solvents.
DO NOT lubricate.
CARE AND CLEANING