CYBEX ATON Q User Manual

TO REMOVE FROM STORAGE
To install the Base using LATCH, the Connectors must be
removed from their storage compartments.
1. To access the LATCH Connector Storage compartments, squeeze
the Level Adjustment Handle to fully extend the Leveling Foot.
2. Remove each connector by pushing the
red button while pulling out.
3. Lengthen the strap between the connectors using the LATCH
Strap Adjuster located next to the connector on the right-hand
side. Push down on the Adjuster button while lengthening strap.
TO STORE
When using a vehicle belt to secure the Base, the LATCH
Connectors MUST be stored in the Base. Loose Connectors
could seriously injure vehicle occupants in the event of a crash.
1. Fully extend the Leveling Foot and slide each connector
back into its Storage slot until an audible CLICK is heard.
2. Close and Lock the Belt Tensioning Plate.
3. Remove any slack from the LATCH strap by pulling
on the LATCH Strap Tensioning Loop.
Do not remove more slack from the LATCH Strap than necessary to
allow it to lie at on the bottom of the Base between the Belt Guides.
4. Retract the Leveling Foot by squeezing the Level
Adjustment Handle and pushing in the Leveling Foot.
26
LATCH STRAP
CLICK!
2
2
3
3
1
1
DO NOT OVERTIGHTEN the Latch Strap, as this will
interfere with the Belt Tensioning Plate when installing
the Base using vehicle belts.
REMOVING AND STORING LATCH CONNECTORS
EN

CYBEX ATON Q Specifications

General

Headrest	Yes
Washing type	Machine wash
Certification	ECE R44/04
Mounting type	Seat belt
Product color	Green
Car seat group	0+ (0 - 13 kg; 0 - 18 months)
Country of origin	Germany
Belt fastening type	3-point
Placement available	Rear-facing
Maximum weight capacity	13 kg
Maximum washing temperature	30 °C
Number of headrest positions	8
Quantity	1

Weight and Dimensions

Depth	650 mm
Width	440 mm
Weight	4600 g
Height (max)	560 mm
Height (min)	390 mm