CYBEX ATON Q User Manual

7. Pull up on Harness Straps to snug around the child's
hips while holding the Harness Buckle in place.
8. Slowly pull the adjuster strap to tighten the Shoulder Straps.
A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child’s
esh or push the child’s body into an unnatural position.
9. Position the center of the Chest Clip even with the
child's armpits. Make sure the Shoulder Pads do not
interfere with the placement of the Chest Clip.
If the Shoulder Pads don't allow a proper t,they can be removed to
provide more space for the Chest Clip. Unsnap to remove.
10. Harness Pinch Test. To test for a properly tightened
Harness, pinch the shoulder strap. A snug Harness
should not allow you to pinch any slack when pinched
between your thumb and forenger. If needed, pull
adjuster strap further for a tight and proper t.
To keep child warm, place a blanket over child and Infant Carrier, AFTER
you have properly secured and tightened Harness around your child.
21
7
8
9
10
ALWAYS KEEP child properly secured in Harness.
NEVER SECURE child in Infant Carrier dressed in a
bulky garment or heavy clothing.
USING THE INFANT CARRIER

CYBEX ATON Q Specifications

General

Headrest	Yes
Washing type	Machine wash
Certification	ECE R44/04
Mounting type	Seat belt
Product color	Green
Car seat group	0+ (0 - 13 kg; 0 - 18 months)
Country of origin	Germany
Belt fastening type	3-point
Placement available	Rear-facing
Maximum weight capacity	13 kg
Maximum washing temperature	30 °C
Number of headrest positions	8
Quantity	1

Weight and Dimensions

Depth	650 mm
Width	440 mm
Weight	4600 g
Height (max)	560 mm
Height (min)	390 mm