Cygnus M3-DIVE - Probe Selection Chart

Cygnus DIVE Operating Manual
M3-DIVE-M-ENG_Iss9.docx
Page 24 of 117
Probe Selection Chart
Use this chart as a guide to selecting the right probe for your
application.
No
Probe Type
Application
S2C
S3C
S5C
S5A
T5B
T2C
1
Painted, coated & bare metals.
Coatings up to 20mm (3/4in)
thick
2
.
Corrosion: non to moderate.
Thickness: 3 to 250mm (1/8in
to 10in)
1
.
Class Shipping Surveys.
General purpose use.
√
2
Painted & bare metals.
Corrosion: non to moderate.
Thickness: 2 to 150mm (0.1in
to 6in)
1
.
√
3
Painted & bare metals.
Corrosion: non to light.
Thickness: 1 to 50mm (0.05in
to 2in)
1
.
√
4
Small diameter pipes.
Boiler tubes.
Corrosion: non to light.
Thickness: 1 to 25mm (0.05in
to 1in)
1
.
√
5
Uncoated or coated metals
3
.
Corrosion: very heavy, pitting.
Thickness: 2.0 to 100mm
(0.08in to 2in)
1
.
General purpose use.
√
6
Uncoated or coated metals
3
;
Cast Iron. Wrought Iron.
Plastics.
Corrosion: very heavy, pitting.
Thickness: 3.0 to 150mm
(0.12in to 6in)
1
.
√