Cygnus M3-DIVE - Using the DIVE Gauge; Turning the Gauge on

Cygnus DIVE Operating Manual
M3-DIVE-M-ENG_Iss9.docx
Page 32 of 117
9. Using the DIVE Gauge
Turning the Gauge On
Fitting a battery to the DIVE gauge will
turn on the gauge.
The gauge will display the Cygnus logo
screen while it starts up.
If the DIVE gauge has gone into standby
mode then press and hold either button
until the gauge turns on (this may take up
to 5 seconds).
Note. Turning the gauge back on from
standby will skip the following two steps.
The next screen displays the Serial
Number, Software Version and Run Time.
You can freeze the screen by pressing any
button, press again to unfreeze and
continue.
Your attention is drawn to the warranty
statement.
The next screen displays a red warning
message reminding you to remove the
battery after use and to re-calibrate before
use.
Press either button to continue.