Cygnus M3-DIVE - A-Scan Display in Single Echo Mode; Surface Preparation

Cygnus DIVE Operating Manual
M3-DIVE-M-ENG_Iss9.docx
Page 37 of 117
When in Multiple Echo mode and a Multiple
Echo verification has been found the three
echo points are marked by three square
boxes.
When in Single Echo mode the echo point
is marked by a single arrow below the X
axis.
A-Scan Display in Single Echo Mode
In Single Echo mode the A-Scan display will always be displayed
and cannot be turned off.
Surface Preparation
The DIVE gauge will not measure through barnacles or similar
hard encrusters. You must therefore remove any hard marine
growth before attempting a thickness measurement, typically
divers use a scraper to do this.