The gauge holds a list of 8 common
materials and their typical velocity of
sound values;
NO CHANGE
MILD STEEL
STAINLESS 302
STAINLESS 314
STAINLESS 316
STEEL DUPLEX F51
ALUMINIUM ALLOYED
CAST IRON GREY
BRASS NAVAL
You can use the material list to quickly set
the gauge to measure different materials.
If you decide not to change the material
simply select the NO CHANGE option.
When the material is selected the gauge
will display a brief confirmation message.
This list uses typical velocity values, in
practice the actual velocity will vary
according to the precise grade and
processing conditions of the material being
measured.
This list is provided as a guide
only. Wherever possible, the
Gauge should always be calibrated on
the material under test.
These Velocities are given in good
faith and are believed to be accurate
within the limits described above. No
liability is accepted for errors.
To Next Page
Loading...
