D-Link DAP-1665

51D-Link DAP-1665 User Manual
Section 3 - Conguration
IPv6
If you are connecting the access point to a network which is using IPv6, the DAP-1665 can be congured to operate using the
IPv6 protocol.
My IPv6
Connection is:
LAN IPv6 Link-
Local Address:
When Link-Local Only is selected, this will set the access point’s
local IPv6 address.
The router’s local IPv6 address will be displayed here. This
address should be used to access the web-based conguration
utility through the IPv6 protocol.
Click Save Settings at the top of the page to save the current
conguration.
My IPv6
Connection is:
LAN IPv6
Address:
Subnet Prex
Length:
Default Gateway:
Primary DNS
Server:
Secondary DNS
Server:
Selecting Static IPv6 from the drop-down menu will allow you
to assign a static IPv6 address to the access point.
Enter the LAN IPv6 Address here. This address should be
supplied by your Internet Service Provider (ISP).
Enter the Prex Length for IPv6 IP addresses on your network.
Enter the default IPv6 gateway address for your network.
Enter the primary IPv6 DNS server address for your network.
Enter the secondary IPv6 DNS server address for your network.
Click Save Settings at the top of the page to save the current
conguration.