D-Link DCS-1130 User Manual

41D-Link DCS-1130 User Manual
Appendix A - Installing the DCS-1130 on a Router Without UPnP
3) Open the HTTP Port
The HTTP port option under Port Detail Settings is used when multiple
cameras are being installed behind a single public IP address and will
beaccessedremotelyORforusingaportotherthanthedefaultportfor
image viewing. For each additional camera that is installed, you must
assign the appropriate Web server port for each camera to enable remote
viewing.
By default, port 80 (Web server port) is open. If these ports are available
for use, you DO NOT have to open a second port and can proceed to
the next section.
If port 80 is not available (for example, if you are already using port 80
to run a Web server or your ISP blocks access on port 80), you MUST
open a second port and designate a new Web server port (800, 801,
802, etc.). Similarly, if port 554 is not available, you will need to open a
differentportforRTSP.
Note:Besuretotakenoteofthesesettingssincethesesamesettingswillbeusedtocongureyourrouter.
Note:SomeISPsblocktrafconcommonlyusedportslikeport80todisallowconsumersfromputtingaserverontheir
network. Be sure to check with your ISP so that you can open the appropriate ports accordingly. If your ISP does not
passtrafconport80,youwillneedtochangetheWebserverportthecamerausesfrom80tosomethingelse,like
800. If you are behind a residential gateway, you will need to open a corresponding port on your gateway as well. Not
allgatewaysarethesame.Pleaserefertoyourgateway’suser’smanualforspecicinstructionsonhowtoforward
ports.

D-Link DCS-1130 Specifications

General

Brand	D-Link
Model	DCS-1130
Category	Security Camera
Language	English