D-Link DCS-5029L - Camera Setup Wizard; Downloading and Running the Wizard

20D-Link DCS-5029L User Manual
Section 2 - Installation
Camera Setup Wizard
If you do not have a mydlink-enabled Cloud Router, you can use either a Windows or Mac computer to go through the Camera
Setup Wizard, which will guide you through the installation process. First you must download the Camera Setup Wizard from
http://www.mydlink.com/support.
Within 20 - 30 seconds, the Setup Wizard will open, which will guide you step-
by-step through the installation process from connecting your hardware to
conguring your camera and registering it with your mydlink account.
Click Start to begin.
Windows Users - Download the Windows Setup Wizard le to your computer.
Mac Users - Download the Mac OS Setup Wizard. Open the SetupWizard le
and launch the application.
Note: At the end of the Setup Wizard, you can click Go To Camera if you wish to access the Conguration Utility. Refer to “Using the Web
Conguration Utility” on page 28.
Note: If you experience issues registering this device with your mydlink account,
perform a hard reset by pressing and holding the reset button on the device for
10 seconds while the device is powered on.