D-Link DCS-5029L User Manual

16D-Link DCS-5029L User Manual
Section 2 - Installation
Zero Conguration Setup
The Zero Conguration Setup will only work with a registered Cloud Router an an active mydlink account. Your Cloud Router
will automatically assign your network settings (both wired and wireless) to your camera, and add the camera to your mydlink
account. If you do not have a D-Link Cloud Router, you can use the Setup Wizard. Refer to “Camera Setup Wizard” on page 20.
Connect the Power Cable and Ethernet Cable
Step 1
Attach the power supply to the power receptor located on the back of the DCS-5029L
and connect it to a wall outlet or surge protector. Power is conrmed when the Power
LED is lit.
Step 2
Connect the included Ethernet cable to the Ethernet port located on the back of
the DCS-5029L. Plug the other end into an available (LAN) port on your D-Link
Cloud Router.
Note: If you later decide to use your camera wirelessly, you will be able to remove the
cable after the Zero Conguration Setup is complete and place the camera within your
wireless network.
If you prefer to initiate a wireless connection with your router, you can use WPS
(Wi-Fi Protected Setup). Refer to “WPS - Push Button Setup” on page 19.

D-Link DCS-5029L Specifications

General

Brand	D-Link
Model	DCS-5029L
Category	Security Camera
Language	English