D-Link DCS-5029L

63D-Link DCS-5029L User Manual 63
Section 4 - Conguration
Maintenance
Admin
This section allows you to change the administrator’s password and congure the settings for your camera. You can also create user account(s)
for individuals allowed to access your camera. These users will only be able to access the Live Video page, and will not be able to change settings.
New Password:
Add User
Account:
User List:
IP Camera Name:
Enable OSD:
Label:
Show Time:
Calibration
Device:
LED Control:
Privacy Control:
To change the admin password used to log into the Web interface, enter the
New Password and enter it again in the next eld to conrm. Click Save.
To create a new user account, enter a User Name, New Password, and enter
the password again in the Retype Password eld to conrm. Click Add. A
maximum of eight user accounts can be created.
Displays a User Name for each authorized user. The administrator can delete
an account by clicking on the Delete button.
Enter a name for your camera.
Check the box to enable the on-screen display (OSD) that you will see when
viewing the video from your camera.
Enter a Label that will be displayed when the OSD is enabled.
Check the box to enable the time-stamp display on the screen, and click
Save to save your settings.
Click Calibrate to ensure that the camera’s pan, tilt, zoom functions correctly.
Should the camera’s P/T/Z function incorrectly, or if the camera has been
jarred, you may need to click the Calibrate button.
When On is selected, the camera’s status LED will function normally. Select
O to disable the status LED. Disabling the LED function may be useful if
you want to make the camera less obvious.
Check the box to enable privacy control. Click Privacy On to put the camera
in Privacy Mode, and click Save. (When privacy mode is turned on, the
camera lens is hidden.)