D-Link DCS-5029L User Manual

39D-Link DCS-5029L User Manual 39
Section 4 - Conguration
Wireless Setup
Check the box to allow your camera to connect to your network
wirelessly.
Click Rescan to scan for an available wireless network. Then click the
drop-down menu to select a wireless network.
Displays the SSID (network name) of the wireless network you want
to connect to.
Select the connection mode used by your wireless network. In most
cases, you should select Infrastructure. Ad-Hoc is only used if your
camera is directly connecting to another PC or device without the use
of a router or access point.
If you are using Ad-Hoc mode, select the same channel that is being
used by your wireless network, or select Auto.
Select the wireless security mode used by your wireless network.
If you select WPA-PSK or WPA2-PSK for your authentication type, you
must specify what type of encryption your wireless network uses.
If you select WPA-PSK or WPA2-PSK for your authentication type,
enter the Key (also known as password) for your wireless network.
Click Save Settings.
Enable
Wireless:
Site Survey:
SSID:
Wireless Mode:
Channel:
Authentication:
Encryption:
Key:
This section allows you to set up and congure the wireless settings on your camera.

D-Link DCS-5029L Specifications

General

Brand	D-Link
Model	DCS-5029L
Category	Security Camera
Language	English