D-Link DCS-5029L User Manual

21D-Link DCS-5029L User Manual
Section 2 - Installation
Manual Hardware Installation
If you prefer to set up your camera without using the Camera Setup Wizard, follow the steps below.
Note: In order to use the mydlink features of this product, you should use either the Camera Setup Wizard or Zero Conguration
Setup. To learn more about mydlink, refer to “Live Video” on page 24.
Optional: WPS (Wi-Fi Protected Setup)
If your router supports WI-Fi Protected Setup, you can use WPS to connect your camera
to your network wirelessly. For more information, refer to “WPS - Push Button Setup”
on page 19. If your router does not support WPS, you will still be able to set up your
camera’s wireless settings using the camera’s Web interface. Refer to “Wireless Setup”
on page 39.
Connect the Power Cable and Ethernet Cable
Step 1
Attach the power supply to the power receptor located on the back of the DCS-5029L
and connect it to a wall outlet or surge protector. Power is conrmed when the Power
LED is lit.
Step 2
Connect the included Ethernet cable to the Ethernet port located on the back of the
DCS-5029L. Plug the other end into an available (LAN) port on your router.
Congure Your Camera
Refer to “Conguration” on page 28 for information on how to congure your camera.

D-Link DCS-5029L Specifications

General

Brand	D-Link
Model	DCS-5029L
Category	Security Camera
Language	English