D-Link DES-3326S - Page 105

D-Link DES-3326S Layer 3 Switch CLI Reference
Status 2 : STP disabled
DES-3326S:4#show stp
Command: show stp
Bridge Parameters Settings
STP Status : Disabled
Max Age : 20
Hello Time : 2
Forward Delay : 15
Priority : 32768
STP Version : STP compatible
TX Hold Count : 3
Forwarding BPDU : Enabled
DES-3326S:4#
show stp ports
Purpose Used to display the Switch’s current per-port
group STP configuration.
Syntax
show stp ports <portlist>
Description This command displays the Switch’s current
per-port group STP configuration.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest Switch number and the beginning
port number on that Switch, separated by a
colon. Then the highest Switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
seperated by a dash. For example, 1:3 specifies
Switch number 1, port 3. 2:4 specifies Switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
Restrictions None
99