D-Link DES-3326S - Page 117

D-Link DES-3326S Layer 3 Switch CLI Reference
config traffic control
Purpose Used to configure broadcast|multicast traffic control.
Syntax
config traffic control [<storm_grouplist>|all] broadcast
[enable|disable]|multicast [enable|disable]|dlf
[enable|disable]|threshold <value>
Description This command is used to configure broadcast storm control.
Parameters
<storm_grouplist> − Used to specify a broadcast storm control
group with the syntax: module_id:group_id.
all − Specifies all broadcast storm control groups on the Switch.
broadcast [enable|disable] − Enables or disables broadcast storm
control.
multicast [enable|disable] − Enables or disables multicast storm
control.
dlf [enable|disable] − Enables or disables dlf traffic control.
threshold <value> − The upper threshold at which the specified
traffic control is Switched on. The <value> is the number of
broadcast|multicast|dlf packets, in Kbps, received by the Switch
that will trigger the storm traffic control measures.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DES-3326S:4#config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DES-3326S:4#
111