D-Link DES-3326S - Page 126

D-Link DES-3326S Layer 3 Switch CLI Reference
config 802.1p user_priority
Purpose Used to map the 802.1p user priority of an incoming packet to
one of the four hadware queues available on the Switch.
Syntax
config 802.1p user_priority <priority 0-7> <class_id 0-3>
Description
The config 802.1p user_priority command is used to configure
the way the Switch will map an incoming packet, based on its
802.1p user priority tag, to one of the four hardware priority
queues available on the Switch. The Switch’s default is to map
the incoming 802.1p priority values to the four hardware queues
according to the following chart:
802.1p Switch Priority Remark
Value Queue
--------- ------------------ -----------
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
Parameters
<priority 0-7> − Specifies which of the 8 802.1p priority values (0
through 7) you want to map to one of the Switch’s hardware
priority queues (<class_id>, 0 through 3).
<class_id 0-3> − Specifies which of the Switch’s hardware priority
queues the 802.1p priority value (specified above) will be mapped
to.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1 user priority on the Switch:
DES-3326S:4# config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DES-3326S:4#
120