D-Link DES-3326S - Page 178

D-Link DES-3326S Layer 3 Switch CLI Reference
config radius add
Purpose Used to configure the settings the Switch will use to communicate with a
Radius server.
Syntax
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default|{auth_port <udp_port_number>| acct_port <udp_port_number>}]
The config radius add command is used to configure the settings the Switch
will use to communicate with a Radius server.
<server_index 1-3> − Assigns a number to the current set of Radius server
settings. Up to 3 groups of Radius server settings can be entered on the
Switch.
<server_ip> − The IP address of the Radius server.
<passwd 32> − The shared-secret key used by the Radius server and the
Switch. Up to 32 characters can be used.
default − Returns all of the ports in the range to their default Radius settings.
acct_port <udp_port_number> − The UDP port number for accounting
requests. The default is 1813.
Only administrator-level users can issue this command.
Description
Parameters
key − Specifies that a password and encryption key will be used between the
Switch and the Radius server.
auth_port <udp_port_number> − The UDP port number for authentication
requests. The default is 1812.
Restrictions
Example usage:
To configure Radius server communication setttings:
DES-3326S:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DES-3326S:4#
172