D-Link DES-3326S - Page 217

D-Link DES-3326S Layer 3 Switch CLI Reference
config dst
Purpose Used to enable and configure time adjustments to allow for the use of Daylight
Savings Time (DST).
Syntax
config dst [disable|repeating {s-week<start_week 1-4,last>
| s-wday <start_weekday sun-sat>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-week <end_week 1-4,last>
| e-wday <end_weekday sun-sat>
| annual {s-date <start_date 1-31>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60|90|120]}
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-date <end_date 1-31>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60 | 90 | 120]}]}
Description DST can be enabled and configured using this command. When enabled this
will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time set
using SNTP service.
Parameters disable -Disable the DST seasonal time adjustment for the Switch.
repeating - Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be specified
using a formula. For example, specify to begin DST on Saturday during the
second week of April and end DST on Sunday during the last week of
October.
annual - Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.
s-week - Configure the week of the month in which DST begins.
<start_week 1-4,last> - The number of the week during the month in which
DST begins where 1 is the first month, 2 is the second month and so on, last is
the last week of the month.
e-week - Configure the week of the month in which DST ends.
<end_week 1-4,last> - The number of the week during the month in which
DST ends where 1 is the first month, 2 is the second month and so on, last is
the last week of the month.
s-wday – Configure the day of the week in which DST begins.
<start_weekday sun-sat> - The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue, wed, thu, fri,
sat)
e-wday - Configure the day of the week in which DST ends.
<end_weekday sun-sat> - The day of the week in which DST ends expressed
211