D-Link DES-3326S - Page 234

D-Link DES-3326S Layer 3 Switch CLI Reference
config route redistribute dst ospf
Purpose
Used to configure route redistribution from RIP to OSPF.
Syntax
config route redistribute dst ospf src [static|rip|local] {mettype [1|2]|metric
<value>}
Description
Route redistribution allows routers on the network − that are running different
routing protocols to exchange routing information. this is accomplished by
comparing the routes stored in the various router’s routing tables and
assigning appropriate metrics. This information is then exchanged among the
various routers according to the individual routers current routing protocol.
The Switch can redistribute routing information between the OSPF and RIP
routing protocols to all routers on the network that are running OSPF or RIP.
Routing information entered into the Static Routing Table on the local Switch is
also redistributed.
Parameters
src − Allows the selection of the protocol of the source device.
dst − Allows the selection of the protocol of the destination device.
mettype − allows the selection of one of the methods for calculating the metric
value. Type-a calculates the metric (for RIP to OSPF) by adding the
destination’s interface cost to the metric entered in the Metric field. Type-2
uses the metric entered in the Metric field without change. This field applies
only when the destination field is OSPF.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Only administrator-level users can issue this command.
Restrictions
Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing
information will be redistributed to OSPF. The following table lists the allowed values for the routing metrics
and the types (or forms) of the routing information that will be redistributed.
Route Source Metric Metric Type
RIP 0 to 16777214 mettype 1
mettype 2
Static 0 to 16777214 mettype 1
mettype 2
Local 0 to 16777214 mettype 1
mettype 2
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed
in OSPF as the metric 20.
Example Usage:
To configure route redistributions:
Command: config route redistribute dst rip src ospf all 1 metric 2
Success.
DES-3326S:4#
DES-3326S:4#config route redistribute dst rip src ospf all metric 2
228