D-Link DES-3326S - Page 239

D-Link DES-3326S Layer 3 Switch CLI Reference
show igmp
Purpose Used to display the IGMP configuration for the
Switch of for a specified IP interface.
show igmp {ipif <ipif_name>}
Description This command will display the IGMP
configuration for the Switch if no IP interface
name is specified. If an IP interface name is
specified, the command will display the IGMP
configuration for that IP interface.
<ipif_name> − The name of the IP interface for
which the IGMP configuration will be displayed.
Restrictions None.
Syntax
Parameters
Example Usage:
To display IGMP configurations:
DES-3326S:4#show igmp
Command: show igmp
Interface I P Address Ver- Query Maximum Robust- Last Member State
sion Response ness Query
Time Value Interval
------------ --------------- ---- ------ -------- ------- ----- -------
System 10.90.90.90 1 125 10 2 1 Enabled
Develop 20.1.1.1 1 125 10 2 1 Enabled
Total Entries: 2
DES-3326S:4#
233