D-Link DES-3326S - Page 242

D-Link DES-3326S Layer 3 Switch CLI Reference
config bootp_relay
Purpose Used to configure the BOOTP relay feature of the
Switch.
Syntax
config bootp_relay {hops <value>} {time
<sec>}
Description This command is used to configure the BOOTP
relay feature.
Parameters
hops <value> − Specifies the maximum number
of relay agent hops that the BOOTP packets can
cross.
time <sec> − If this time is exceeded, the Switch
will relay the BOOTP packet.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To configure bootp relay status.
DES-3326S:4#config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
DES-3326S:4#
236