D-Link DES-3326S - Page 270

D-Link DES-3326S Layer 3 Switch CLI Reference
enable pim
Purpose Used to enable PIM function on the Switch.
Syntax
enable pim
Description This command will enable PIM for the Switch.
PIM settings must first be configured for specific
IP interfaces using config pim command.
Parameters None.
Restrictions Only administrator-level users can use this
command.
Usage Example:
To enable PIM as previously configured on the Switch:
DES-3326S:4#enable pim
Command: enable pim
DES-3326S:4#
Success.
264