D-Link DES-3326S - Page 273

D-Link DES-3326S Layer 3 Switch CLI Reference
show pim
Purpose Used to display current PIM configuration.
Syntax
show pim {ipif <ipif_name 12>}
Description This command will list current PIM configuration
settings for a specified IP interface or all IP
interfaces.
Parameters ipif – The name of an IP interface for which PIM
settings are listed.
If no parameters are specified, all PIM settings
are displayed for all interfaces.
Restrictions None.
Usage Example:
To display PIM settings as configured on the Switch:
DES-3326S:4#show pim
Command: show pim
PIM Global State : Disabled
PIM-DM Interface Table
Hello Join|Prune
Interface IP Address Interval Interval State
------------ --------------- -------- ---------- --------
System 10.90.90.90 35 0 Enabled
Total Entries : 1
DES-3326S:4#
267