D-Link DES-3326S - Page 287

D-Link DES-3326S Layer 3 Switch CLI Reference
Virtual Interface Configuration
Transit Virtual Hello Dead Authentication Link
Area ID Neighbor Router Interval Interval Status
----------- --------------- -------- -------- -------------- ------
10.0.0.0 20.0.0.0 10 60 None DOWN
10.1.1.1 20.1.1.1 10 60 None DOWN
Total Entries : 2
OSPF Area Aggregation Settings
Area ID Aggregated LSDB Advertise
Network Address Type
--------------- ------------------ -------- ---------
Total Entries : 0
OSPF Host Route Settings
Host Address Metric Area ID TOS
--------------- ------ --------------- ---
10.3.3.3 1 10.1.1.1 0
Total Entries : 1
DES-3326S:4#
create ospf area
Purpose Used to configure OSPF area settings.
Syntax
create ospf area <area_id> type [normal|stub]
{stub_summary [enable|disable]|metric
<value>}]
Description This command is used to create an OSPF area
and configure its settings.
Parameters
<area_id> − The OSPF area ID.
type − The OSPF area mode of operation − stub
or normal.
stub_summary − enables or disables the OSPF
area to import summary LSA advertisements.
<value> − The OSPF area cost between 0 and
65535. The default is 0.
Restrictions Only administrator-level users can issue this
command.
Usage Example:
To create an OSPF area:
281