D-Link DES-3326S - Page 302

D-Link DES-3326S Layer 3 Switch CLI Reference
show ospf virtual neighbor
Purpose Used to display the current OSPF virtual
neighbor router table.
Syntax
show ospf virtual_neighbor {<area_id>
<neighbor id>}
Description This command will display the current OSPF
virtual neighbor router table.
Parameters
<area_id> − A 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
<neighbor_id> − The OSPF router ID for the
neighbor. This is a 32-bit number in the form of
an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area’s Area Border Router.
Restrictions None.
DES-3326S:4#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
DES-3326S:4#
Usage Example
To display the current OSPF virtual neighbor table:
Transit Router ID of IP Address of Virtual Neighbor
Area ID Virtual Neighbor Virtual Neighbor State
--------------- ---------------- --------------- ----------------
10.1.1.1 10.2.3.4 10.48.74.111 Exchange
296